Flashcomm: communicate with flash chips wired to a Rapsberry Pi over SPI.

Status: Read/program flash tested on N25Q032A, IS25LP064D and M25P10A flash chips.

Program/read/verify flash chips Get the flash ID

Example commands:

flashcomm --getid
flashcomm --program filename.bin
flashcomm --verify filename.bin

To configure, use a flashcomm.conf file like this: [SPI] bus=0 device=0 max_speed_hz=1000000 ss=27 #Chip Select line of the Flash chip

#optional: set_high=22 #This line is set high before (and during) programming (default: -1, don't use) set_low=-1 #This line is set low before (and during) programming (default: -1, don't use)